Connect Panel to the PDS (cont.)
Secure the cables to the PDS using the watertight strain relief
fittings. Thread the fitting into the box, then slide the rubber
stopper into the fitting. Tighten the cap to create a seal.
Verify all unused holes of the PDS box have the plugs installed.
Reinstall the access cover. Do not overtighten. Refer to the "PDS
Connection Key".
Plug the PDS power cord into the outlet.
Refer to the Digital Interface User Guide to test the overhead rain
panel for proper functionality. Refer to the "PDS Connection Key".
Troubleshooting
This troubleshooting guide is for general aid only. For service and
installation issues or concerns, call 1-800-4-KOHLER.
Troubleshooting Table
Symptoms
Probable Cause
1.
Rainshower
A. No power to PDS.
does not light.
B. No power to
C. Cable connections
D. PDS fuse is blown.
E. Media module is
F.
1078520-2-A
Recommended Action
A. Unplug the PDS and
remove the access
cover. Plug the PDS
into the outlet. If the
LED light is not lit,
check power to
outlet.
B. Verify media module
media module.
is plugged in. Check
power to the outlet.
C. Check cables and
to media module
connections, replace
are loose or
cables if necessary.
damaged.
D. Replace the fuse.
E. Contact a Kohler
not assigning an
Authorized Service
address to the PDS.
Representative.
PDS failure.
F.
Contact a Kohler
Authorized Service
Representative.
22
Kohler Co.