Operating Buttons Of The Remote Control; Deleting The Remote Control - Schwaiger SECURE-4-YOU Serie Manual De Instrucciones

USER MANUAL HG1000 532
7.3. Bedientasten der Fernbedienung
ARM
HOME
ALERT By pressing the
being set off by a sensor, a doorbell noise ("ding dong") sounds.
HOME By pressing the
PANIC Pressing the
ARM/DISARM Using these buttons, you can activate (ARM) or deactivate (DISARM) the system.
7.4. Deletion of remote controls
If a remote control has become damaged or lost, this can be deleted from the system as follows.
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
delete mode.
Step 7
In the LCD display, now, the
total number of the other remote
controls that remain in the system
flashes.
(An additional beep gives acoustic
feedback about the successful
deletion remote control)
24
ALERT
DISARM
ALERT button, the centre switches into doorbell mode. In this case, upon
HOME button, the centre switches into home mode.
HOME and ALERT buttons at the same time sets off an alarm immediately.
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
In the display, now, the total
"5"
number of remote controls that are
integrated into the system, flashes.
(e.g. in the case of 3 registered
remote controls, "03")
Step 8
Confirm the setting using
The centre now automatically
switches into the Standby Mode
again.
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Now enter the ID number of the
remote control that should be
deleted via the operating buttons,
e.g. "02".
➜ If 00 is entered, all registered
remote controls are deleted.
.