Querying The Id Number Of A Remote Control; Setting The House Security Code; Setting The Zone Codes (For Sensors) - Schwaiger SECURE-4-YOU Serie Manual De Instrucciones

USER MANUAL HG1000 532

7.5. Querying the ID number of a remote control

If you are not sure which ID number each remote control has, this can be determined as follows:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button "8" in order to get into the
query mode.
Step 7
Now the relevant number of the
remote control flashes in the
display.

7.6. Setting the house security code

In most cases of use this code
If, however, for example, due to frequent false alarms, you suspect that neighbours in your area use alarm
systems of the same type, you are recommended to change the house security code.
Important:
If you wish to make changes to the house security code,
(centre, remote control, individual components).
All devices have a 4-polar jumper / DIP switch (usually in the battery compartment or under an additional
cover). Ensure that, later, all devices have exactly the same setting of this jumper. In this, the following applies:
Inserted = ON / removed =
Jumper for the house
code
DIP switch for the house
code

7.7. Setting the zone codes (for sensors)

The sensors are supplied with a pre-programmed allocation of zones. The door/window sensors are set for zones
1 and 2; the movement sensor for zone 8. These zones can be set according to your choice with the help of the
jumper.
To do this, open the cover of the relevant product and set this to the required zone. To do this, remove the jumper
of the previous contact by pulling it carefully and then plug this on the required contact pair for the new zone.
Jumper for zone code
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now, the current number of remote
controls that are registered in the
system, flashes.
(If, for example, there are 3 remo-
te controls that are registered, "03"
is displayed here)
Step 8
To leave this mode, press
centre now automatically switches
into the Standby Mode again.
does not need to be changed.
OFF
• Central unit
• Sensors
Standard Code
1: ON, 2: ON, 3: ON, 4: ON
• Remote control
Standard Code
1: ON, 2: ON, 3: ON, 4: ON
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Now press any button on the re-
mote control for which you wish to
determine an ID number.
. The
this must be completed for all components
Standard settings
Door/window sensor = zone 1
Door/window sensor = zone 2
Movement sensor = Zone 8
25