For Massachusetts Installations; Kit Contents; Tools Required - Thermador SGS304FS Manual Del Usuario

For Massachusetts Installations:

1. Installation must be performed by
a qualified or licensed contractor,
plumber, or gas fitter qualified or
licensed by the state, province, or
region.
2. Shut-off valve must be a "T" handle
gas cock.
3. Flexible gas connector must not be
longer than 36 inches.
CAUTION:
When connecting the unit to the propane
gas, make certain the propane gas tank
is equipped with its own high pressure
regulator. In addition, a pressure
regulator was supplied with the cooktop.
This second regulator must be installed
with the cooktop. The maximum gas
pressure to this appliance is not to
exceed 14.0 inches water column from
the propane gas tank regulator.
The following must be met when testing
supply piping system:
a) The appliance and its individual shut-
off valve must be disconnected from
the gas supply piping system at test
pressures in excess of 1/2 psig (3.5 kPa).
b) The appliance must be isolated from
the gas supply piping system by closing
its individual manual shut-off valve during
any pressure testing of the gas supply
piping system at test pressures equal to
or less than 1/2 psig (3.5 kPa).
2

Kit Contents:

Component
Conversion Kit Instructions
Conversion Sticker
Foam Tape
12.5mm T Venturi
10.5mm Venturi
9mm T Venturi
117 Orifice
91 Orifice
74 Orifice
Note:
Depending on model, the kit may contain more
components than necessary to complete your
conversion.

Tools Required:

7 mm Socket Driver w/ 3" minimum extension
20 mm Socket
Flat-head Screwdriver (small)
Main Orifices SGS304FS
117 Front Right – 15000 BTU/hr
91 Front Left – 9100 BTU/hr
91 Rear Left – 9100 BTU/hr
74 Rear Right – 6000 BTU/hr
Main Orifices SGS/X305FS & SGS/X365FS
117 Center – 15000 BTU/hr
91 Front Right – 9100 BTU/hr
91 Rear Left – 9100 BTU/hr
74 Front Left – 6000 BTU/hr
74 Rear Right – 6000 BTU/hr
Quantity
1
1
1
2
1
2
1
2
2