3. Securing Your Baby; 3.1 Securing Your Baby Using The Baby Insert; 3.2 How To Adjust The Belts, Headrest And; Seat Positions - Be Cool atomic Manual Del Usuario

SECURING YOUR BABY
3
3 .1 Securing your baby using the baby
insert
For the protection of your baby
Always secure your baby in the car seat using the
harness.
Never leave your baby unattended in the car seat when
placing it on elevated surfaces (e.g. a table, nappy
changing unit, etc.).
Never allow the strap end to become caught in moving
parts (e.g. automatic doors, escalators, etc.).
Caution! The plastic parts of the car seat heat up in the
sun, so that your baby may get burnt. Protect your baby
and the car seat against intensive solar radiation (e.g. by
putting a light cloth over the seat).
The car seat requires only one seating position in the
car. This advantage means, however, that your baby
must be in a semi-reclined position.
Take your baby out of the car seat as often as possible
to relieve its spine.
We recommend frequent breaks during long journeys.
Even outside of
IM 2093 ,00_ATOMIC.indd 41
the car, please avoid leaving your baby in the car seat
for too long.
3 .2 How to adjust the belts, headrest
and seat positions

IMPORTANT:

The correct belt height of the shoul-
der belts is attained when the belt disappears into
the shell slightly above the shoulder of the child.
Make sure that the shoulder belts fit properly over
the shoulders of the child.
3 .2-1 Adjusting the belts
Loosen the harness straps by pressing the release
button and pulling the harness straps as for as you can.
Note! Do not pull the Shoulder pads.
3 .2-2 Nine heights of the headrest
The headrest can be set at five different heights in
group 1 mode with the shoulder belts axle in place.
There are four additional positions in Group 2 modeon-
ce the shoulder belts axle and harness straps hasbeen
taken off.
EN
41
20/2/19 17:16