Be Cool atomic Manual Del Usuario página 46

EN
Unlock the shoulder belts from the connecting piece.
Pull the shoulder strap axle out, until the shoulder strap
and pull the harness strap out from the harness slot.
Open the harness buckle and take off the lower part
of the cover, then put the buckle and should belts into
storage compartments.
Remove 5-point harness system then remove the
headrest cover and the shell cover.
5 .2 Refitting the 5-point harness sys-
tem and cover
After washing, place the cover on the shell.
Loosen the lower part of the cover and then take
out the buckle and shoulder belt from the storage
compartments.
Put the end of the shoulder strap through the
harness slot, fix into shoulder strap axle, and lock the
shoulderstrap axle to the seat shell.
Also put the end of the harness strap through the
harness strap slot and shell, fix into the strap yoke,
46 make sure the seat strap can not be twisted.
IM 2093 ,00_ATOMIC.indd 46
Close the buckle, then fasten the cover all around.
Check that it works!
The child seat must not be used without the
seat cover.
20/2/19 17:16