Continuity Measurements - Southwire 16030A Instrucciones De Operación

Operation cont.

Continuity Measurements

WARNING:
Never test continuity on a live circuit.
1. Press the button to turn the meter on.
2. Press the button until the " " symbol
appears on the display.
3. Insert the black test lead into the COM input
jack and the red test lead into the V
4. Touch the test lead probes to the device or wire
under test.
5. A beeper will sound if the resistance is approx.
50 or less and the resistance value will be
shown on the LCD display.
NOTE: The meter will automatically switch to voltage
if connected to a live circuit (> 2.6V)
CAT IV 600V
COM
COM COM
input jack.
WIRE
9
Operation cont.
Non-contact AC Voltage Detection: 100V to 600V
WARNING:
Risk of Electrocution. Before use, always test the
Voltage Detector on a known live circuit that is within the defined detection
range to verify proper operation.
1. Press the button to turn the meter on.
2. Hold the detector probe close to the AC
voltage being tested.
3. If AC voltage within the specified range
is present, the indicator light will illuminate.
NOTE: Insulation type and thickness, and distance from the voltage source
and other factors may effect operation. Use other methods to verify live
voltage if there is any uncertainty.
NOTE: The detector is designed with high sensitivity. Static electricity or other
sources of energy may randomly activate the sensor. This is normal operation.
NOTE: The detector only activates the indicator light when AC voltage is
present. It does not indicate the voltage level on the LCD display.
10