Downloading Further Instructions - Balluff BTL7-A510-M Serie Instrucciones Breves

BTL7-A/C/E/G5 _ _ -M _ _ _ _ -K(8)-SR32/_ _ _
Micropulse Transducer - Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL7 Micropulse Transducer, together with a machine
controller (e.g. PLC), comprises a position measuring
system. It is intended to be installed into a machine or
system. Flawless function in accordance with the specifi-
cations in the technical data is ensured only when using
original BALLUFF accessories. Use of any other compon-
ents will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position measu-
ring system will not result in hazards to persons or equip-
ment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.
BTL7...-SR32
34 40-1
6
2)
Mounting
25
surface
20.5
2) Unusable area
3) Not included in scope of delivery
4) The bending radius for a fixed cable must be at
least five times the cable diameter.
1 english
Nominal length =
Measuring range
3)
Magnet
Version
...-K-...
...-K8-...

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
Dimensions and function
The BTL7 transducer contains the waveguide which is
protected by an outer stainless steel tube (rod). A magnet
is moved along the waveguide. This magnet is connected
to the system part whose position is to be determined.
1) Not for BTL7-...-F_ _
2)
Damping zone
60
G
D1 G
10.2 mm Thread
M4x4/6 deep
8 mm No thread
BTL7...-Cable
r
20.5
File No. 1)
E227256
Ø 79
Ø 64
6 holes for
mounting
the transducer
4)