15.3.1 Adjusting The Sawing Angle - HOLZMANN MASCHINEN TK 305 Manual De Intrucciones

1. Install the extend pole
Hold the "extend pole" with your hand. Then insert it to
the hole of the base side until it to go on; when the pole
and hole are in a straight line.
As same as the other side.
2. Use the clamp groupware to work.
a) Put the board on the "circular pan" ;
b) Reference "location ruler" to select a cutting length,
then screw up the "clamp groupware" knob until it to
clamp the board.
Use the mitre saw
c) Hold the handle and trigger switch;
d) Press the "mitre drop & lock button" down;
e) Push down the mitre head to cut the board.
f) If the cutting board too short. So you must use the
"safety push stick".
g) Cutting the board until it to server.
h) Loosen the trigger of the mitre, until it rise slowly.
i) Release your hand
j)

15.3.1 Adjusting the sawing angle

The default angle between the saw blade and the circular
pan is 90°. Use a 5mm hex key to check the angle between
the saw blade and the circular pan.
3. Loose the "Mitre swing and control angle knob"
4. Loose the "verticalis lock screw, Then swing the mitre
handle when the indicator stay a 0°.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
42
TK 305