Tubes Feed Head; Automatic Feed Head - Robot Coupe CL 55 e Manual De Instruccion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Slide the hinge pin
into the hinge rings
provided at the back of
the motor base.
Next, lock the lid onto
the motor unit using the
locking handle.
- Fill the feeder right up to the top with vegetables.
- Lower the pusher so that it is flush with the top of
the feed opening.
- Press the pusher down to guide the food through
the machine. The exact amount of pressure
required will depend on the nature of the cut,
bearing in mind that too much force reduces
cutting quality without increasing throughput.
- Cut cabbages in half and remove the core before
processing, in order to avoid unnecessary strain
and ensure an end-product of a higher quality.
- Lift the pusher and allow access to the feed tube.
• tUBeS feed HeAdS
Position the 4-tubes hopper, or the straight and
inclined tube hopper, on the motor unit. The locking
handle should now be facing you, on the right.
Slip the hinge pin into
the locations provided
at the back of the motor
base. The locking handle
should now be facing
you, on the right.
• AUtOMAtIC feed-HeAd
et
Proceed as specified for the pusher-feed
head.
Screw the agitator
onto the motor shaft.
P o s i t i o n
automatic hopper on
the motor base. The
fastening hook is now
facing you on your right.
Slide the hinge pin
into the slots provided
a t t h e b a c k o f t h e
m o t o r b a s e . T h e n ,
lock the lid onto the
motor base using the
fastening hook.
The machine should be switched off (by pressing the
red push-button) before starting to change the disc.
With the motor unit facing you, use your right
hand to release the aluminium fastening hook
used to lock the hopper onto the motor base.
a) feed opening fitted with a lever:
t h e
Lift the pusher and release the bowl by tilting
it to the left so that the hopper can be tittled
backwards. Then inscrew the loading cone or
the hollowing cutter. For the hollowing cutter,
use the dismantling tool provided for that
purpose.
b) With hole feed-head:
First remove the inserts and the pushers and
then lift the fastening hook in order to tilt the
hopper backwards to release the bowl.
c) Automatic feeder:
Lift the fastening hook in order to tilt the
hopper backwards to release the bowl.
Insert the pusher feed-
head into the feed tube
and turn it until the plastic
part is correctly wedged
inside the tube.
CHAngIng
tHe dISCS
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido