Recording (5) - Analog-Source Recording - HHB CDR-850 Instrucciones De Operación

CU-PD084
FADER
REPEAT
6
1
2
INPUT SELECTOR
DIGITAL
COAX
OPT
AES/
EBU
3
RECORD
4
REC LEVEL L
4
3
2
1
0
5
or / ou / o
6
64
<PRE1282>
En
1
3 2 4
5 6
4
R-800
REC
TRACK NO.
WRITE
5
OPEN/
CLOSE
ANALOG
XLR
+4dBu
XLR
–8dBu
LINE
REC
R
5
6
7
8
9
10
RECORDING (5) – ANALOG-SOURCE
RECORDING
This recording mode is for recording analog
signals from sources such as cassette, vinyl
records or analog mixing consoles.
The following instructions explain how to perform analog
recording.
÷ Connect the analog input correctly to the XLR (balanced)
or line (unbalanced) input sockets.
1
Load a CD-R or CD-RW disc containing space
for recording. If the disc is finalized recording
will not be possible.
÷ After loading the disc check, the CD-R or CD-RW indicator
stops blinking and lights steadily.
2
Select the input to be used for recording with
the INPUT SELECTOR.
÷ Select XLR +4dBu, XLR –8dBu, or LINE (phono sockets)
3
Press the RECORD ¶ button, or press the two ¶
REC buttons on the remote control unit.
÷ This unit enters record-pause mode.
4
Adjust the recording level. (Refer to page 68 for
the recording level adjustment method.)
÷ Start playback of the source component to set the recording
level. When the recording level is set, stop playback of the
source component, and proceed to step 5.
÷ The margin indicator can be a useful reference when setting
the recording level (page 42).
5
Press the 8 or 3 button on this unit.
÷ Press the 8 or 3 buttons after the counter displays "00:00".
÷ Start playback of the source player after having started the
recording of this unit.
÷ Track numbers are automatically updated when the AUTO
TRACK indicator is on. This function assumes that silent
passages longer than 2 seconds mark the area between two
tracks and automatically starts a new track number when a
sound is detected next. Passages with a low input level or
noise during passages that are supposed to be silent causes
the function to misjudge where new track numbers should
be created. In cases like these, set the AUTO TRACK level
lower or create new track numbers manually (pages 80).
6
After recording is complete, press the 7 button
to end recording.
÷ "PMA REC" is displayed and the unit stops after recording
the track data.