Axxess AXDI-FD1 Instrucciones De Instalación página 3

INSTALLATION
With the key in the off position:
• Connect the AXDI-FD1 harness into the interface, and then to the wiring harness in the vehicle.
Note: Both connectors of the AXDI-FD1 harness must be connected to the vehicle.
• Connect the 8-pin sub/center harness to the wiring harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the AXDI-FD1, with the key
in the off position.
PROGRAMMING
Attention! If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an AXSWC connect it after you initialize and test the interface/
radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
3
REV. 1/23/2020 INSTAXDI-FD1