Husky 32220 Instrucciones De Instalación página 8

Figure 8
Base Rail Pin
9. Grease the latch pin and free end of the long tube assembly #2 which is connected to the driver's side
roller assembly. See Figure 3. Slide it into Hole #1 of the passenger side roller assembly so that the latch
pin inserts into hole #2. See Figure 3 & 9. Place the roller housing assembly onto the passenger side of
the installed base rails and pin in place with the base rail pins and hair pins supplied with base rail kit.
See Figure 1 for correct slot use. See Figure 8 for base rail pin orientation. The base rail pin MUST point
AWAY from ALL the anti-lift screws on both roller assemblies
10. Attach handle assembly #7 onto short tube assembly #3 for Husky 16K-S 31313. Loosely
assemble using 1/4" bolt #9 and 1/4" nut #8. See Figure 10. Use short handle assembly #11 if using
th
Husky 16K-W 5 wheel 31326.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
for Warranty Information / Tech Support ©2014 Husky Towing Products Revision: June 03, 2014-REV 4
Anti-lift Screw
Rear of Truck
#2
#7 or #11
Page 8 of 42
Hair Pin
Figure 9
Rear of Truck
Figure 10
Rear of Truck
www.huskytow.com