Quick Controls - Steinberg PADSHOP Manual Del Usario

Option
Grain Duration
Grain Length
Grain Pitch
Grain Formant
Grain Level
Step Modulator
Frequency
Step Modulator Slope Modulates the Slope parameter of the step modulator.
Amplitude Envelope
Attack, Decay,
Sustain, and Release
Filter Envelope Attack,
Decay, Sustain, and
Release
Bus 1-16

Quick Controls

Padshop provides a predefined set of eight quick controls that can be controlled
directly from within Cubase or Nuendo.
By default, these quick controls are assigned to the following parameters:
Quick control
1
2
3
4
5
6
7
8
You can also change the default quick controls assignments. For more information,
see the Operation Manual of your Steinberg sequencer application.
Description
Modulates the grain duration, that is, the frequency at which the
grains repeat.
Modulates the Length parameter.
Modulates the pitch of a grain. The modulation is not continuous,
but is updated at the start of a new grain. For continuous pitch
modulation, use Pitch instead of "Grain Pitch" as destination.
Modulates the pitch of the source sample independently from the
grain duration. This results in formant shifting for short durations.
Modulates the grain level. The modulation is not continuous, but is
updated at the start of each new grain. For continuous level
modulation, use the destinations Volume 1, Volume 2, or Level.
Modulates the Frequency parameter of the step modulator.
Modulates the time of the amplitude envelope attack, decay,
sustain, and release, respectively. These parameters cannot be
modulated continuously. The time is updated only when the
segment starts.
Modulates the time of the filter envelope attack, decay, sustain,
and release, respectively. These parameters cannot be modulated
continuously. The time is updated only when the segment starts.
You can send any modulation to one of the sixteen busses, for
example, to produce more complex modulation signals. Select the
bus you want to send the signals to as a destination. To use the
modulation that was sent to a bus, assign the corresponding bus
as a modulation source.
Parameter
Layer A Filter Cutoff
Layer A Filter Resonance
Layer A DCA Attack
Layer A DCA Release
Layer B Filter Cutoff
Layer B Filter Resonance
Layer B DCA Attack
Layer B DCA Release
26
Padshop/Padshop Pro
Quick Controls