Appliance Handling Safety; Safety Codes And Standards; Electric Safety - Gaggenau VG 414 210 CA Instrucciones De Instalación

9
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
IMPOR TANT : THE APPLIANCE HAS TO BE
INSTALLED BY A QUALIFIED INSTALLER.
INSTALLER: LEAVE THESE INSTRUCTIONS WITH
THE APPLIANCE AFTER INSTALLATION IS
COMPLETE. IMPORTANT: SAVE FOR THE LOCAL
INSPECTOR'S USE.
WARNING
If the information in this manual is not followed
exactly, fire or shock may result causing property
damage or personal injury.
WARNING
Do not repair, replace or remove any part of the
appliance unless specifically recommended in the
manuals. Improper installation, service or
maintenance can cause injury or property damage.
Refer to this manual for guidance. All other servicing
should be done by a qualified technician.
Improper installation can mean to lose the warranty.

Appliance Handling Safety

Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with one or more of the
following Standards:
▯
UL 858, The Standard for the Safety of Household
Electric Ranges
▯
UL 923, The Standard for the Safety of Microwave
Cooking Appliances
▯
UL 507, The Standard for the Safety of Electric
Fans
▯
ANSI Z21.1, The American National Standard for
Household Cooking Gas Appliances
▯
CAN/CSA -C22.2 No. 113-M1984 Fans and
Ventilators
▯
CAN/CSA -C22.2 No. 61-M89 Household Cooking
Ranges
6
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1.
The appliance must be electrically grounded in
accordance with local codes or, in the absence of
local codes, with the National Electrical Code ANSI/
NFPA 70, latest edition. (In Canada, installation must
be in accordance with the CAN 1-B149.1 and .2
Installation Codes for Gas Burning Appliances and/
or local codes.)

Electric Safety

WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged
into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether
the wall receptacle is properly grounded, the
customer should have it checked by a qualified
electrician.
If required by the National Electrical Code (or
Canadian Electrical Code), this appliance must be
installed on a separate branch circuit.
The circuit breaker should have a contact separation
of at least 3 mm on all poles.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply
with all applicable codes.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Installer – show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.