<EN>
• Enter the new emergency code that you have decided on. Remember
that it must have a minimum of 1 and a maximum of 12 digits.
• Press the
• For
• Press the
The safe will emit a long beep for acceptance if the process has been
completed correctly. If there has been an error it will emit four short
beeps. In this second case the opening code has not been changed and
you will have to repeat the process.
REMEMBER:
Never keep the envelope containing the emergency key and
emergency code inside the safe, in case you need to use them.
5. USE OF THE EXTERNAL BATTERY CHARGER:
In the event that the safe has
emergency key, you can open the safe by using 1 external 9V battery.
Proceed in the following manner:
• Connect the 2 extremes of the battery to the 2 power points that are
on the keypad (+ y -).
• Open the safe in the normal way (
6. CONDITION OF THE BATTERY INDICATOR:
Each time that you use the safe, the electronic system
condition of the batteries. If the condition is good, the safe uses the
green light during the opening process. If the batteries are low the safe
uses the red light.
Once you see that the safe is using the red light, you should change the
batteries that are found on the inside of the door. The safe is able to
carry out several openings after the appearance of the red light. Even
so, do not rely on this and change the batteries as soon as possible.
key.
re-enter your new emergency code.
key again.
batteries and you do not have the
- code -
).
the