Measurement Procedure Of The Probes; Temperature Menu; Units; Delta T - Chauvin Arnoux C.A 1051 Manual De Instrucciones

4. MEASUREMENT PROCEDURE OF THE PROBES

To switch on the instrument, press the key « ON / OFF » for few seconds.
The screen shows the name of the device, its serial number, its calibration date, the date and hour.
Connect the corresponding probe to the type of measurement which you wish to carry out to reach
the various menus.
It is not possible at the same time to connect more than one probe.
The apparatus automatically recognizes the inserted model and the screen displays the type of probe.
Press then on th knob « OK » to reach the menu.
To return to the homepage, disconnect the probe.
To switch off the instrument, press some seconds on the « ON/OFF » key.

4.1 Temperature menu

It is possible to connect up to 2 probes thermocouple K at the same time. The measured value is shown
on the screen and the following menu appears on the last line (by browsing the menu by scrolling down
the knob) :

Units.

Delta T (only if 2 probes of identical technology are connected).
To validate a function, press on the knob when the wished function is shown on the screen.
4.1.1 Units
Browse the different available units by scrolling down the knob and validate pressing on the knob.
When you have the choice between various parameters, you have to validate each unit of measure.
4.1.2 Delta T (only if 2 probes of identical technology are connected)
When 2 thermocouple K probes are connected, you have the possibility of calculate the Delta T which
corresponds to the difference between the temperature measured by (T1 and T2).
To come out of this function, press on the knob.
20