Lubrification; Getting Repair Service Or Technical Assistance; Ordering Accessories And Replacement Parts - Federal Signal Vitalite 121A Instrucciones De Instalación Y Mantenimiento

2. See Figure 1 on page 10. Remove the screw located at the
bottom of the dome.
3. Grasp the top of the dome and push it down while turning the
dome counter-clockwise approximately 3/4-inch.
4. Gently lift the dome away. Ensure the gasket between the
dome and base is not lost.
5. Use a soft cloth and any liquid household cleaner to gently
clean the reflector. DO NOT USE abrasive cleaners.
6. Before replacing dome, ensure that the gasket is properly
seated on the housing base.
7. Place the dome over the base while aligning the recesses
inside the dome lip with the four pins on the base. Push down
on the dome and turn it clockwise until it locks in place
(approximately 3/4-inch).
8. Replace and tighten the screw in the bottom of the dome.

Lubrification

The Motor-Gear Reducer Assembly is a sealed unit. Therefore, no
lubrication is required.

Getting Repair Service or Technical Assistance

Products returned for repair require a Return Authorization form
from your local distributor or from Federal Signal. To obtain
repair service or technical assistance from Federal Signal, call
708-534-4756 or 877-289-3246. For instruction manuals and
information on related products, visit:
http://www.federalsignal-indust.com.

Ordering Accessories and Replacement Parts

Typical spare parts are listed in Table 1 on page 12. To order
accessories and replacement parts, call Federal Signal Customer
Support at 708-534-4756 or 877-289-3246.
Models 121A and 121S Vitalite
Installation and Maintenance Instructions
Rotating Light
®
11