Battery Replacement - Klein Tools ET260 Manual De Instrucciones

ENGLISH
OPERATING INSTRUCTIONS
TESTING IN CAT III / CAT IV MEASUREMENT LOCATIONS
Ensure the test lead shield is pressed firmly in place. Failure to use
the CATIII / CATIV shield increases arc-flash risk.
5/32"
(4 mm)
TESTING IN CAT II MEASUREMENT LOCATIONS
CAT III / CAT IV shields may be removed for CAT II locations. This
will allow testing on recessed conductors such as standard wall
outlets. Take care not to lose the shields.
AC/DC VOLTAGE (LESS THAN 690V)
Apply test leads to the system under test to measure voltage; the
voltage measured will be reflected in the display. The tester will
automatically detect the presence of AC or DC voltage and illuminate
the appropriate icon in the display.
CAUTION: The maximum testing voltage is 690V. 'OL' will show
in the display if voltage in excess of 690V is detected. No other
warnings will be delivered for voltages above 690V. Testing voltages
above 690V should not be attempted under any circumstances.
6
.7" (18 mm)
OPERATING INSTRUCTIONS
CONTINUITY
Remove power from circuit. Test for continuity by applying test leads
to the system being tested. The tester automatically enters continuity
testing mode. If resistance < 270kΩ is detected, an audible signal will
sound and the continuity icon " " will show in the display indicating
continuity. If the circuit is open, "
DO NOT attempt to measure continuity on a live circuit.
MAINTENANCE

BATTERY REPLACEMENT

When the Low Battery indicator shows low battery strength (
batteries must be replaced.
1. Remove 2 screws from battery door.
2. Replace 3 x 1.5V AAA batteries (note proper polarity).
3. Replace battery door and fasten securely with screws.
To avoid risk of electric shock, disconnect leads from any voltage
source before removing battery door.
To avoid risk of electric shock, do not operate tester while
battery door is removed.
NOTE: There are no user-serviceable parts inside tester.
" will show in the display.
),
7