Removal From The Wheelchair - Permobil ROHO AGILITY Manual Del Operador

Removal from the Wheelchair

Warnings:
- DO NOT perform any tasks without first reading and understanding all of the safety information and provided instructions.
- DO NOT remove or install the AGILITY while the individual is seated in the wheelchair.
- DROPPING, PINCHING, CRUSHING RISK: The AGILITY with Direct Mount Hardware is heavy. To avoid injury, hold securely and use
extreme caution when installing, adjusting, removing or otherwise handling the AGILITY with Direct Mount Hardware. Ask for
assistance if needed.
To remove AGILITY and the Direct Mount Hardware
1. If a headrest
is installed,
remove it.
2. Loosen the four
nylon-insert
lock nuts,
then slide the
AGILITY up as
far as it will go.
3. To keep the AGILITY from
sliding up or down during
removal, securely tighten
one of the lock nuts.
ROHO AGILITY Direct Mount Hardware Operation Manual
4. Remove the AGILITY with the Direct Mount Hardware:
a. Remove the cap screw, which is
b. Lift upward and then away from the
OPTION: Remove the AGILITY and Direct Mount Hardware
separately:
a. Remove the four lock nuts and
b. Remove the AGILITY from
c. Replace the four washers
d. Remove the cap screw.
e. Lift upward and then
10
located beneath the lower front of the
cover.
wheelchair to remove the AGILITY and
the Direct Mount Hardware. The four
keyholes on the Direct Mount Hardware
will disengage from the four
pins on the wheelchair.
washers.
the wheelchair, but do
not remove the Direct
Mount Hardware from the
wheelchair.
and lock nuts on the bolts.
away from the wheelchair
to remove the Direct
Mount Hardware from the
wheelchair.
Cap screw
Cap Screw