Permobil ROHO AGILITY Manual Del Operador página 9

Installation On the Wheelchair, continued
To install:
3. Attach the Direct Mount Hardware to the wheelchair:
a. Hold the AGILITY firmly and securely and fit the four keyholes
of the Direct Mount Hardware over the four pins on the
wheelchair.
b. Then slide the AGILITY straight down until it is securely
attached.
IMPORTANT! All four keyholes MUST engage with all four
pins.
4. Secure the Direct Mount Hardware and adjust the height of
AGILITY:
a. Place the cap screw in the opening and tighten until snug
+ one-quarter turn. After all pins are engaged with all four
keyholes, the cap screw will keep the Direct Mount Hardware
attached to the wheelchair. The opening for the cap screw is
located beneath the lower front of the cover.
Note: If you are not able to access the cap screw,
install only the Direct Mount Hardware (without the
AGILITY) on the wheelchair and secure it with the cap
screw. Then install the AGILITY on the Direct Mount
Hardware.
Warning: Tightening the cap screw does NOT
necessarily mean that the Direct Mount Hardware is
securely installed. The cap screw can be tightened while
the pins are NOT fully engaged in the keyholes. After
tightening the cap screw, test for a secure installation by
pushing forward on the AGILITY (toward the front of the
wheelchair).
b. IMPORTANT! Test to Make Sure the Direct Mount Hardware
is Securely Installed: Push forward on the AGILITY (toward
the front of the wheelchair). It should NOT move forward if
all four pins are engaged with all four keyholes. If it moves,
repeat the installation instructions on this page and then test
again.
Warning: If the Direct Mount Hardware is not
securely attached to the wheelchair, the product is NOT
safe to use.
c. IMPORTANT! Adjust the height of AGILITY to fit the
individual: To ensure a correct fit for the individual, adjust the
height. Refer to the height adjustment instructions and safety
information on the next page.
ROHO AGILITY Direct Mount Hardware Operation Manual
7
AGILITY Cover
Cap screw (x1)
The opening for the cap screw is the same opening used for
the "knob" on the wheelchair (see the previous page).
Keyhole (x 4)
Pin (x 4)