EdilKamin H2OCEANO 23 Instalación Uso Y Mantenimiento página 27

External air regulation
external air intake, regulates the quantity of primary air neces-
sary for combustion.
Push the knob to close the external air intake; pull the knob to
open the external air intake.
OPTIONAL THERMOSTATIC VALVE (FIG. 2)
Manual adjustment of combustion air (to be carried out
during installation)
To obtain the desired water temperature, manually calibrate the
thermostatic valve.
the thermostatic valve using the screw located just below the
move the manual air intake damper by removing the valve and
Automatic adjustment of combustion air
The combustion air is captured by the external air intake via the
If the temperature inside the hearth is low,compared to that set
during calibration, the valve automatically positions itself in
the open position and vice versa, it closes when the temperature
is high.
This allows the right quantity of wood to be consumed for the
set thermal comfort to be reached and unnecessary waste is
avoided.
stion air inlet completely (the temperature in the hearth is very
enter and keep the glass clean.
X
INSTRUCTIONS FOR USE
E
-
V
Y
Installation of thermostatic valve "V" is optional.
place off and fully cooled.
The mains power must also be disconnected.
- Open the door and block it in the open position in order
therefore to remove it simply lift it up (keep in mind that
base and hearth).
- Install the pre-assembled thermostatic valve on the
- Secure the plate with the three screws supplied (S) to
the probe wire through the prepared slots.
- The adjustment cable must be inserted into the front
position using the elastic ring supplied.
- The probe wire must be unwound along the right side of
the ash pan proceeding then to the outside of the thermo
-
- At this point insert the probe in the well on the thermo
- Before putting back the hearth base check the wear con-
dition of the gasket (if necessary replace it) and insert the
- 27
-
-
-