Kohler K-705700 Guia De Instalacion página 11

Apply Silicone Sealant.
Side Lite
Filler
6.Install the Side Lite Glass Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass edge directly on the floor.
Place a bushing in the remaining bottom hole of the side lite glass panel.
Place the gaskets over the edges of the side lite panel.
Using your hands, place the wall jamb on the edge of the side lite glass panel, opposite the attached
hinge and exactly in the middle of the vertical edge of the side lite.
Important! Apply a bead of silicone sealant to the groove of the side lite filler.
Place the side lite glass panel onto the pins of the L-brackets.
IMPORTANT! Make sure the glass panel is as close to the wall as possible while still remaining plumb.
Place the outside plates onto the pins of each of the L-brackets and securely fasten with the
supplied screws.
Wipe off excess silicone sealant.
Position the bottom hinge bracket parallel with the bottom track. Use a level to align the front face
of the bracket with the front face of the bottom track.
Temporarily attach the bracket with masking tape or a clamp, making sure there is no gap.
Insert the self-tapping screw into the hole of the bottom hinge bracket and carefully thread the
screw into the bottom track (do not overtighten or it may strip the screw.)
Remove any visible aluminium chips.
Insert one of the hinge pins completely into the bottom hinge bracket.
Kohler Co.
Wall Jamb
Outside Plate
Screw
Bushing
Gasket
"L" Bracket
11 1064866-2-C