Kohler K-705700 Guia De Instalacion página 7

2. Measure and Cut the Bottom Track
CAUTION: Risk of personal injury. Always wear safety glasses while cutting.
NOTE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
Measure from wall to wall at the bottom of the shower door opening. This is distance "D".
Subtract 1/16" (2 mm) from distance "D." The resulting dimension is the bottom track cut length.
Mark the bottom track at the determined distance.
NOTE: For best results use a miter box and 32-tooth per inch hacksaw to make the cut.
Cut the bottom track at the mark.
File the rough edges smooth where the bottom track was cut, taking care to avoid damaging
finished surfaces.
The cut bottom track should sit flush on the threshold without hand pressure or tape to hold it
down.
Kohler Co.
Measure
here.
Measure distance "D"
above curves in the
corners.
Angled
Base
Important: Measure carefully. If your walls are
curved or angled, measure above the curve or
angle. Failure to do so can result in an improperly
cut bottom track.
Measure
here.
Curved
Base
D
7 1064866-2-C