Kohler K-1652 Guia De Instalacion página 7

Pitch toward
generator.
Steam Head
Drain/Spill Pan
Do not run pipes
down and then up.
2. Install the Piping
WARNING: Risk of personal injury or property damage. Do not plumb the pressure relief valve
into the steam line. Plumbing the pressure relief valve into the steam line can create a hazard if the
steam line is blocked or obstructed.
WARNING: Risk of personal injury. Do not plumb a trap in the steam line or plumb the pressure
relief valve into the steam line. Plumbing the pressure relief valve into the steam line can be
hazardous if the steam outlet is capped.
WARNING: Risk of personal injury or property damage. Do not direct the pressure relief valve to
the enclosure. In the event the pressure relief valve activates, the hot water may spray causing
burns to the user and/or damage the enclosure. Therefore, the pressure relief valve should be
directed to an area where damage will not occur from contact with hot water and should conform
to national and local plumbing codes.
NOTICE: Do not apply excessive heat to the generator connections when soldering. Do not apply flux or
acids directly to the generator, as damage to the seals, plastic components, and trim finish may result. Do
not apply petroleum-based lubricants to the generator components as damage may result.
NOTICE: When installing the control pad, allow room in the control cable for a drip loop. The drip loop
will discourage moisture from following the control cable to the steam generator.
Connect a tee to the existing cold water line.
Install the brass shut-off valve to the tee.
NOTICE: The in-line water filter (recommended) must be installed between the shut-off valve and the
steam generator inlet.
If applicable, install the recommended in-line water filter to the shut-off valve.
Kohler Co.
Provide clearance
from wall.
Steam Trap
7
1" (2.5 cm)
Min
6" (15.2 cm)
from Floor
2-1/2"
(6.4 cm)
Wall Stud
1008019-2-K