Transportation And Storage - Ivoclar digital PrograMill Dry Instrucciones De Uso

EN 6

Transportation and storage

WARNING
Injuries caused by unsafe transportation
If you transport the machine unsafely, the machine
may slip and cause injuries.
Always transport unpacked machines indi-
vidually and do not stack them.
Ensure that only trained personnel transport the
machine to and from the installation site.
Ensure that the housing of the machine is com-
pletely closed.
Always transport the machine in an upright posi-
tion.
Transport and position the machine with as many
people as required for the weight of the machine in
accordance with local and / or national laws and
regulations.
Before carrying an unpacked machine, install the
carrying aid that was provided with the machine
and ensure that all components are properly fixed.
Do not use a different carrying aid.
Grab unpacked machines only at the
handles of the carrying aid. Do not tilt the
machine when carrying it.
NOTICE
Short-circuit hazard when the machine is too cold
If the machine is transported from a cold environment
into a warmer environment, a short circuit may occur
caused by condensate.
Before switching on the machine after trans-
portation, ensure the following:
The ambient air has the allowed temperature.
n
The machine has the same temperature as the
n
ambient air. This will take at least 48 hours.
The machine is completely dry.
n
The supplement about the carrying aid and
transport lock is delivered with the machine.
It is also downloadable at
https://www.ivoclarvivadent.com
Preparing transportation or storage
Before transporting or storing your machine, the
following preparations are necessary:
Repackaging
To repack the machine after preparing its trans-
portation or storage, the following steps are necessary:
.
Operating Instructions: PrograMill Dry
Version: 2/19/2021
PrograMill Dry – Operating regulations
Ensure that the following conditions are met during
the whole transport and / or storage period:
Permitted ambient conditions for storage / trans-
n
port:
– Ambient temperature (storage / transport):
between -20°C (-4 °F) and 60°C (140 °F)
– Relative air moisture: max. 80 %, non-
condensing
1. Remove all materials from the working chamber.
2. Clean the working chamber. Ensure that the work-
ing chamber is completely dry.
3. Install the transport lock. For this, follow the cor-
responding steps on the supplement.
4. Ensure that the housing of the machine is com-
pletely closed.
5. Switch off the machine at the main power switch.
6. Disassemble the machine components by fol-
lowing the installation instructions in reverse
order.
7. If you need to carry the machine, install the car-
rying aid. For this, follow the corresponding steps
on the supplement.
8. In case of overseas transport, take proper mea-
sures against corrosion.
1. If possible, use the original packaging. If the orig-
inal packaging is not available, use a packaging
of similar size and quality.
2. Pack the machine and its accessories securely.
3. Protect the packaging against slipping. If
machines are properly packed and protected
against slipping, they may be stacked.