Ivoclar digital PrograMill Dry Instrucciones De Uso página 70

EN 22
4. To insert the material to be processed, do the fol-
lowing:
a. If the material is a multilayer material, ori-
entate the material so that the top shade
layer is on top.
b. If the disc has been processed before,
ensure the following:
The original top side faces upwards.
n
If the disc has been marked for safe
n
remounting in PrograMill CNC, make
sure that the marking is in the position
shown below.
c. Position the material in the material holder.
F . 18 – I
IG NSERTING A DISC INTO THE MATERIAL HOLDER
(
POSITION FOR SAFE REMOUNTING MARKED BLUE
)
F
Operating Instructions: PrograMill Dry
Version: 2/19/2021
PrograMill Dry – Operation: Preparing jobs
NOTICE
Damaging of the machine / tools or bad
machining results due to improper material
fixation
If the material holder is not closed correctly, the
material will not be properly fixated and the
material holder may get damaged. As a result, the
machine and tools may get damaged and the
machining results may not be satisfactory.
Always close the material holder as it is
described below.
Ensure that the material holder levers are
firmly closed.
Do not apply excessive force when closing
the levers.
5. To close the material holder, do the following:
a. Make sure the material holder levers are in
the front position, as indicated in the figure
below.
b. Push down the material holder cover and
hold it in place.
c. Lock the material holder by pushing the left
and / or right material holder lever (marked
orange in the figure) away from yourself until
you notice a distinct resistance and the
levers are firmly closed. Do not apply exces-
sive force.
. 19 – C
IG LOSING THE MATERIAL HOLDER
The disc is fixated in the material holder. The disc
is mounted in the working chamber.