Job Interruptions And Job Abortions; How To Proceed In Case Of A Job Interruption; How To Proceed In Case Of A Machine Mal; How To Proceed In Case Of A Tool Breakage - Ivoclar digital PrograMill Dry Instrucciones De Uso

EN 26
F . 23 – R
IG EMOVING THE TOOL FROM THE COLLET
CHUCK
8. Close the working chamber door.
9. Confirm the current message.
The following happens:
a. The collet chuck closes.
b. The working chamber door closes.
c. The spindle moves to its default position.

Job interruptions and job abortions

A job will be interrupted in the following cases:
The compressed air supply is not sufficient
n
The vacuum in the working chamber is not suf-
n
ficient
An interrupted job will normally be continued auto-
matically after the error is corrected.
A job will be aborted in the following cases:
In case of a machine malfunction
n
In case of a tool breakage
n
In case of a power failure
n
If a job was aborted , you have to restart it.

How to proceed in case of a job interruption

If the job was interrupted, PrograMill CNC displays a
corresponding message.
If the compressed air is insufficient
Check the following:
The manometer of the compressed air regulator
n
The installation of the pneumatic hoses
n
Your compressor
n
If the vacuum is insufficient
Check the suction hose and your suction unit as
well as the connection cable between the machine
and the suction unit.

How to proceed in case of a machine mal-

function
A machine malfunction is recognized by the internal
control unit in case of a critical event. The working
chamber will be illuminated in red. PrograMill CNC
displays the error message and error code that was
sent by the control unit.

How to proceed in case of a tool breakage

If a tool breaks during machining, the machine will not
recognize this immediately. Instead, the spindle will
continue to move with the broken tool. The tool
breakage will be recognized upon the following
events:
A tool breakage can be caused by the following:
If a tool breaks, do the following:
Operating Instructions: PrograMill Dry
Version: 2/19/2021
PrograMill Dry – Operation: Processing jobs
1. Record the error message and error code that is
displayed.
2. Restart the machine and the CNC computer. If the
problem persists, continue with the next step.
3. Disconnect the machine from the electrical source
and prevent it from being restarted.
4. Contact your service partner. Have the error mes-
sage and error code readily available.
5. If you need to remove a material from the working
chamber, perform an emergency opening of the
working chamber door.
The next regular tool change
n
The next check for broken tools, if activated in the
n
application settings of PrograMill CNC.
The tool was damaged or worn
n
The tool was put into the wrong tool magazine
n
position or was manually inserted into the
spindle at the wrong time. As a consequence, it
was not suitable for the processing step.
The distribution of the objects in the material
n
("nesting") was not correct.
1. Open the working chamber door.
2. Remove all parts of the broken tool from the work-
ing chamber and the collet chuck.
3. If the spindle picked up the tool from the tool
magazine, check if the tool was inserted into the
correct position. Insert a spare tool into the correct
position in the tool magazine.
4. If you manually inserted the tool into the collet
chuck, check if the broken tool corresponds to the
tool type which you were prompted to insert. Have
a correct spare tool ready.
5. Close the working chamber door. Restart the job.