Ivoclar digital PrograMill Dry Instrucciones De Uso página 87

PrograMill Dry – Troubleshooting guide
Is the measuring key contaminated?
If applicable:
Clean the measuring key with a brush.
Are the tools worn?
How to check this:
1. Visually inspect all tools.
2. Check the tool life values in PrograMill CNC.
3. Replace worn tools with new ones.
Do rings on the tools sit in the groove on the tool
shank?
How to check this:
Visually inspect all tools and push rings that have
moved into the groove again.
Are the tool magazine inserts worn?
If applicable:
Replace the tool magazine inserts with new ones.
Do the parameters of the job in the software corre-
sponding to the parameters of the material?
How to check this:
Make sure that the following parameters of the job
and of the material in the machine correspond to
each other. Also make sure that they are suitable
for the objects that you want to machine.
Material type
n
Material measurements
n
Application types of the individual objects
n
Do you use the latest version of the manufacturing
software that is released for the machine?
To update PrograMill CAM and PrograMill CNC, fol-
low the instructions in the documentation for the
manufacturing software.
1. Change to PrograMill CNC on the CNC computer.
2. Update the software by clicking the symbol shown
in the lower right corner of the PrograMill CNC
window.
it loosely seated in the spindle?
mended interval?
The computer interrupts the job and displays
that the air pressure is too low

regulator
supply system?
Operating Instructions: PrograMill Dry
Version: 2/19/2021
3. Follow the instruction of the installation wizard.
4. Start PrograMill CNC
Are the object files of sufficient quality?
How to check this:
1. Check the quality of object files (STL files) in your
CAD application or an STL viewer. Especially,
consider the manufacturer information on wall
thickness and border thickness.
2. If necessary, adjust the settings of your scanner
and scan application.
Is the collet chuck of the spindle contaminated or is
If applicable:
1. Clean the collet chuck with the provided spindle
service set.
2. When you insert the collet chuck into the spindle,
make sure that it is properly seated.
Did you exchange the collet chuck at the recom-
How to check this:
Verify the recommended interval for exchanging
the collet chuck in the maintenance table. If neces-
sary, exchange the collet chuck.
You can resolve this problem while the job
execution is interrupted. PrograMill CNC
continues the job as soon as the problem is
resolved.
Is the compressed air regulator properly set?
Set the air pressure at the compressed air regu-
lator to a correct value.
Adjusting the air pressure with the compressed air
– on page 17
Is the error caused by the external compressed air
How to check this:
1. Close the main external compressed air supply
valve.
2. Check if all pneumatic hoses are properly seated
in their connections and are undamaged.
3. Check if your compressor is switched on and set
correctly.
4. Open all required valves of your compressed air
supply system.
EN 39