Valve Assembly - Enerpac VP Serie Hoja De Instrucciones

7.0 WM10 REMOTE MANIFOLD
The WM10 Remote Manifold allows mounting of the valve stack
at a location removed from the pumping unit. The manifold has
a built in relief valve.
7.1 Relief Valve Adjustment
1. Loosen lock nut counter-clockwise.
2. Turn adjustment screw clockwise to increase or counter-
clockwise to decrease pressure.
3. Tighten lock nut (3 ft.-lbs. [4-Nm]) clockwise while holding
pressure setting.
NOTE: Valves may be mounted to Global Workholding Pump
with the "WM12" manifold in place of "WM 10" remote
manifold.
REMOTE MANIFOLD SPECIFICATIONS
Fluid Temperature Range -13°-176°F [-25°-80°C]
Viscosity Range
Hydraulic Oil
Flow Rate
Operating Pressure
Relief Valve Adjustment
Weight
G .1/4" BSPP Ports
Pressure and Return
40,0
9,6
18,1
Note: All dimensions are for reference only
Figure 13. REMOTE MANIFOLD
150-165 S.U.S. [15-250c.St]
HLP 23 ISO 3448-1975
427 CU.IN/MIN [7,0 L/M] MAX
5,000 psi [350 Bar] {35 MPa}
0-5,000 psi [350 Bar] Range
{35 MPa}
2.50 LB [1,1 kg]
72,5
40,0
Adjustable
Relief
Valve
8.0 TIE ROD KITS AND VALVE ASSEMBLY
The valve stacks are held together by tie rods. The tie rods
when secured in place are designed to hold the stack together
and provide a leak-free seal between valves. The tie rod kits
can accommodate valve stacks ranging from one to eight
valves.

8.1 Valve Assembly

1. Position valve manifold "WM10" with valve locator pins facing
up, (see Item 1, Figure 15). Screw both tie rods into manifold
(end with short thread length).
2. Stack desired valves and accessories (see Items 2, 3, and 4,
Figure 15). Make sure that locator pins and mating holes line
up.
3. Install end plate over tie rods (see Item 5, Figure 15).
4. Install seal washer over each tie rod (see Item 8, Figure 15).
5. Install 10mm cap nut over each tie rod (see Item 9, Figure
15). Torque to 5.5 ft. lbs. (7,5 Nm).
5