Descargar Imprimir esta página

Prior To Commissioning; Squeegee Assembly; Filling The Fresh Water Tank - diversey TASKI swingo 755B Power Manual Del Usuario

Ocultar thumbs Ver también para TASKI swingo 755B Power:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 87

Prior to commissioning

Relocation drive
• Switch on the machine (key switch).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op-
eration. (In case of malfunctions,
please see page 81).
• Take the driving handle and arrange
the height of the driving switches in
such a way that you can work easily
with them.
• By gently pushing the driving switch
into the direction of movement, the
machine is set into motion. If you let
go of the driving switch, the machine
will stop.
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
Variant: Automatic brush lowering (Option 1255B)
• Press the Brush drive button ON/
OFF.
While lowering the brush will slowly
start to pulse. In this way the tool is
centered and engaged.
The display lights up.
Variant: Foot pedal
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
Notice:
When the brush is down, gently moving the ma-
chine back and forth can make the clutch easier to
engage.
74

Squeegee assembly

• The machine must be switched off (main switch).
• Position the suction nozzle (2) below
the suction nozzle holder (1).
1
1
2
2
• Press the foot pedal down until the
suction nozzle holder engages.
• Attach the suction hose to the con-
nector.

Filling the fresh water tank

Caution:
Max. permissible water temperature 60 °C/140 °F.
- Diversey recommends using cold water, as hot water
will adjust to the ground temperature as soon as it
comes into contact with the ground. Thus there are no
advantages to using hot water.
• The machine must be switched off (main switch).
• Put your hand into the opening be-
tween tank cover and tank.
Palms upwards.
• Open the tank cover until the support engages in the tank
wall.
• Remove the dosage aid.
• Fill the fresh water tank with water.
Maximum filling level (page 70).
• Tip the tank cover back into its original position and press
it down until it locks.

Publicidad

loading