Reprocessing The Mask Between Patients; Reassembling The Mask; Elbow Reassembly; Mask Reassembly - ResMed Mirage Quattro Manual De Instrucciones

Handwash the mask by gently rubbing in warm (86°F / 30°C) water using mild
soap or diluted dishwashing detergent.
Do not twist the valve during cleaning as this may damage or tear the valve
membrane or hinge. Take care when handling the valve.
If the vent requires cleaning use a soft bristle brush.
Rinse all components well with drinking quality water and allow them to air dry
out of direct sunlight. Do not soak the mask.
Weekly
Handwash the headgear in warm (approx. 86°F/30°C) water using mild soap or
diluted dishwashing detergent. Rinse well and allow it to air dry out of direct
sunlight.

Reprocessing the Mask between Patients

Only Sleep Lab Mask (SLM) variants of the mask are intended for multi-patient
re-use. When using between patients, these masks must be reprocessed
according to cleaning and disinfection instructions available on ResMed.com/
downloads/masks.

Reassembling the Mask

See section D on the illustrations sheet.
Before reassembling the mask, check that all components are clean and dry.
Check that the valve is not damaged, distorted or torn, and that none of the
other components are broken or cracked. Replace any parts that are damaged.

Elbow Reassembly

1 Insert the valve into the valve clip (Fig. D-1).
2 Push the valve clip onto the elbow (Fig. D-2). Make sure both sides click into
place (Fig. D-3).
3 Insert the swivel into the end of the elbow (Fig. D-4).
4 Insert the assembled elbow (Fig. D-5) into the mask frame.

Mask Reassembly

1 Fit the cushion clip into the grooved edge of the mask cushion. Fit the top
section first, then work your way around, pushing the clip into the cushion
(Fig. D-6). Ensure that the cushion is not twisted or distorted around the
clip.
2 Align the cushion clip with the mask frame. Push the cushion clip into the
mask frame, ensuring that all three clips click into place (Fig. D-7).
3 Push the forehead pads firmly into the forehead support (Fig. D-8).
5