Nova-500 Operation; Making Emergency Broadcast From Front Panel - Optimus NOVA-500 Manual De Instalación Y Funcionamiento

6. LAN Input. (NOVA‐500 only)
Ethernet connection used to connect the PC software and set up the system.
7. Bus Extension connectors.
Extension input output connectors, used to connect the bus between equipment.
8. System Memory Card. (NOVA‐500 only)
SD card where all system settings, messages and configuration, are stored.
9. Grounding interface.
10. Standby power amplifier interface.
0 dB Audio output and 100V audio input, used con connect a standby power amplifier.
11. FAULT output.
Output contact activated when any failure is detected.
12. EVAC state output.
Output contact activated during emergency.
13. Fire alarm reset input interface.
Close this contact to reset Emergency mode.
14. XLR Line input interface.
0 dB audio input.
15. XLR Line input interface.
0 dB audio input.
16. INPUT 1‐6 audio sensitivity adjustment.
17. RCA Line input interfaces.
0 dB audio inputs.
18. Host REC Output.
0 dB audio output. It broadcast the same audio. It broadcasts the same audio as 100 V output
2.3. NOVA‐500 OPERATION
2.3.1. Making Emergency broadcast from front panel
-
Emergency mode is activated by manual pressing the EMERGENCY button. BGM is cut
immediately, all zones are unselected, and EMERGENCY button lights red.
-
Select the zones and press front panel microphone PTT button or ALERT or EVAC messages.
PPT button need to be kept pressing to make the announcement.
-
Priority is Microphone > EVAC message > ALERT message.
-
If no zones are selected, voice/message is broadcast to all zones.
-
In order to Reset Emergency Mode, press EMERGENCY button again.
NOVA Version 1.0
NOVA
Voice Evacuation System
Page 8 of 34