Assembly; Assembling Frame And Wheels; Fueling The Heater; Kerosene (#1-K) - Mi-T-M MH-0150-0MDF Manual Del Usario

Remove the heater and all packaging materials fromt he shipping carton. Tip: Be sure to remove the axle from the side of the
Styrofoam packaging.
Note: Tools required: phillips screw driver, 8mm open end wrench, 19mm open end wrench. Tip: Use a power screwdriver and
locking wrench for easier assembly.

ASSEMBLING FRAME AND WHEELS

1. Insert axle through holes in wheel support.
2. Slide then spacer onto axle.
3. Slide wheel onto axle with the air valve facing out and hold in place with the axle nuts.
4. Place heater on wheel support frame and line up holes on the fuel tank lip.
5. Attach front handle with (4) long screws (55mm) and (4) nuts through the second and third hole from the
front on both sides of the tank lip and wheel support frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first hole the front of the tank lip and tighten firmly. Make certain
all (6) screws are secure.
7. Attach rear handle with (4) long screws (55 mm) and (4) nuts through the first and second hole from the rear
on both sides of the tank lip and wheel support frame and tighten firmly.
8. Attach front guard with the included hardware.
Wheel Support Frame
Tire
Axle Nut
Figure 2

FUELING THE HEATER

DANGER: NEVER REFUEL THIS HEATER
WHILE IT IS HOT OR OPERATING. FIRE
OR EXPLOSION COULD RESULT.
CAUTION: NEVER FILL THE FUEL TANK
INDOORS. ALWAYS
OUTDOORS. BE SURE THAT THE HEATER
IS ON LEVEL GROUND WHEN FUELING,
AND NEVER OVERFILL THE FUEL TANK.
WARNING: DO NOT USE GASOLINE OR CRANKCASE DRAININGS.

KEROSENE (#1-K)

For optimal performance of this heater, it is strongly suggested that #1-K kerosene be used. #1-K kero-
sene has been refined to virtually eliminate contaminants, such as sulfur, which can cause a rotten egg
odor during the operation of the heater. Using diesel fuel can cause excess soot production. Do not use
bio-diesel as this fuel will damage your heater's seals and filter.
WARNING: CSA CERTIFIED FOR USE WITH 1-K KEROSENE, NO. 1 AND NO. 2 DIESEL, JP8/JET A
FUEL, NO. 1 AND NO. 2 FUEL OIL.
Kerosene Portable Heaters Manual

ASSEMBLY

Axle
Spacer
FILL THE TANK
Safety Guard
Wheel Support Frame
Figure 3
Handle
11