Reassembling The Reduction Unit - Interpump Group Pratissoli KS Serie Manual De Reparación

- Remove the pinion using an extractor hammer to be
applied on the M12 hole (Fig. 20).
- Unscrew the bolts fastening the reduction gearbox, then
remove it (Fig. 21).
2.1.6

Reassembling the reduction unit

- Pre-assemble the reduction gearbox bearing using
ordinary tools.
- Position the gasket (Fig. 22) and mount the reduction
gearbox, taking care to enter the hole in the reduction
gearbox with the reference pin on the casing (Fig. 23,
pos. ).
- Secure the reduction gearbox with the 6 M8x50 screws
and calibrate the screws with a torque wrench (Fig. 24) as
indicated in chapter 3.
Fig. 20
- Insert the crown wheel on the shaft, place the washer
in between and tighten the fixing screw with a torque
wrench (Fig. 25) to the torque setting indicated in
chapter 3.
Fig. 21
Fig. 22
23
Fig. 23
Fig. 24
Fig. 25