Chicco StyleGo Up Manual Del Usuario página 15

BUCKLES FOR CAR SEAT BELTS
18. To fasten the two buckles on the pins located at the
p- ends of the carrycot (fig. 18A), insert each buckle in the
to pin pushing it (fig. 18B) and pulling the buckle down
until you hear a click (fig. 18C).
of WARNING: Do not assemble the buckles backwards! (fig. 18D).
his The carrycot is now ready to be positioned in the car.
FASTENING THE CARRYCOT IN THE CAR
us
so 19. To fasten the carrycot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
be seat belts of the two outer seats (fig. 19).
en 20. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carrycot can be fastened also shift-
he ed to one side occupying the middle seat and lateral
Do seat using the seat belts of these two seats (fig. 20).
not 21. Pull and fasten the two seat belts in the seat's buckles
(fig. 21).
Recline the carrycot backrest completely
it WARNING: Never use the carrycot in the car with the back-
rest raised! Safety is not guaranteed!
cot Follow the steps below on both sides:
its 22. Take the seat belt and make a loop (fig. 22);
wn 23. Take the car kit buckle and rotate the buckle's red bar
ns. outward (fig. 23).
AR 24. Insert the loop you've made in the seat belt in the buck-
ey le (fig. 24A – 24B) and rotate the red bar to its initial po-
sition so that it fits inside the loop (fig. 24C).
ed 25. Pull the seat belt toward the retractor pressing the car-
rycot against the seat so that it is fastened well (fig. 25A).
WARNING: Make sure that the carrycot is fit against the
se
backrest and seat.
WARNING: Make sure that the belts are tensioned (fig. 25B).
REMOVING THE CARRYCOT FROM THE CAR SEAT
ed
04. Follow the steps below on both sides.
ith 26. Unfasten the buckle from the carrycot pulling the buck-
le's red tab outward and pushing (fig. 26) to release the
of carrycot from the seat belt. The buckle is left fastened
our to the seat belt.
WARNING: Never use the seat belt to fasten passenger
en-
without removing the CAR KIT buckle: it can be dangerous!
al" 27. To remove the buckle from the belt, loosen the loop in
p- the belt (fig. 27A) and rotate the red bar so that it comes
out (fig. 27B).
or
FASTENING THE CARRYCOT TO THE STROLLER
N/
Prepare the stroller to assemble the carrycot according to
nu- the stroller's instructions.
For use with the stroller, make sure to remove the safety
belts following the steps in paragraph CARRYCOT SAFETY
HARNESS AND COMFORT KIT in reverse order.
WARNING: The restraint system must be removed when
in
the product is used outside the car.
WARNING: To fasten the carrycot to the stroller structure,
int remove the seat first.
NI/ 28. Hold the handle in carrying position (vertical) and posi-
tion the carrycot in the vertical joints making sure that
the two vertical mechanisms are outside the carrycot
HE
until you hear the click confirming fastening. Place the
carrycot with the baby's feet end facing the stroller's
ns handle (fig. 28A). To facilitate fastening the carrycot on
the stroller, there are labels with instructions on both
sides of the fabric showing you the correct alignment of
the carrycot with the fasteners (fig. 28B).
WARNING: Before using, make sure that the carrycot is
properly locked on by pulling on it upwards.
REMOVING THE CARRYCOT FROM THE STROLLER
29. Position the handle in the carrying position (vertical),
pull the button on the front of the carrycot outwards
(fig. 29A) and while keeping the button raised remove
the carry out from the stroller structure by pulling it up
(fig. 29B).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carrycot; howev-
er, these operations may be more difficult to execute due
to the child's weight. Pay attention when carrying out the
above mentioned operations.
Important Note: The images and instructions in this manual
refer to a single carrycot version. Some of the components
and functions described here may vary depending on the
model purchased.
WARRANTY
The product is guaranteed against any conformity defect
in normal conditions of use as provided for by the instruc-
tions for use. The warranty shall not therefore apply in the
case of damages caused by improper use, wear or acciden-
tal events. For the duration of the warranty on conformity
defects please refer to the specific provisions of applicable
national laws in the country of purchase.
15