Kohler K-2035 Guia De Instalacion página 5

Sink Anchor
Holes
Self-Adhesive
Gaskets
2. Install the Angle Brackets
NOTE: This product is heavy. Get help when lifting and securing
the sink and shroud.
With assistance, carefully lift the sink into place on the hanger
bracket and level the sink. Adjust the hanger bracket as needed.
On the underside of the sink, locate and mark the sink anchor
holes on the finished wall.
Apply six self-adhesive gaskets to the top of the shroud as
shown.
With assistance, carefully position and center the shroud tight
against the underside of the sink. Mark the three shroud hole
locations on the finished wall.
Carefully remove the shroud and sink.
Draw a level line connecting the top shroud hole marks. Measure
2-1/8" (54 mm) on each side of the centerline to mark the top two
angle bracket holes.
For the bottom angle bracket hole, measure and mark the
centerline 1-5/8" (41 mm) above the bottom shroud hole mark.
Kohler Co.
Sink Anchor
Holes
2-1/8" (54 mm)
Angle Bracket
Holes
Lag Bolt
5
2-1/8"
(54 mm)
1-5/8"
(41 mm)
1015627-2-D