Kohler K-2035 Guia De Instalacion página 7

Offset
Screwdriver
Washer
Angle Bracket
Screw
3. Install the Sink and Shroud
IMPORTANT! The sink must be supported by the hanger bracket.
Drill 1/4" sink anchor holes at the marked locations.
Carefully set the sink on the hanger bracket. Level the sink.
Install the faucet and drain to the sink according to the
manufacturer's instructions.
Connect and tighten the trap to the drain. Complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
NOTICE: Risk of product damage. Vitreous material can crack or
chip. Do not overtighten the hanger bolts or angle bracket screws.
Carefully position the shroud under the sink.
Partially thread the angle bracket screws. For a snug fit against
the sink, tighten the bottom screw first. Then, use an offset
screwdriver to tighten the top screws. Do not overtighten!
Thread the bolt caps onto the hanger bolts. Secure the sink to the
wall with the hanger bolts and washers. Tighten until snug. Do
not overtighten!
Kohler Co.
Sink Anchor
Holes
Washer
Bolt Cap
Hanger Bolt
7 1015627-2-D