Installation - pony CLASSIC 110 Instalación Funcionamiento Y Mantenimiento

E N G L I S H
Capitolo 4 dfdgdhh

INSTALLATION

PACKING
The machine is packed in a box closed with an
adhesive band.
TRANSPORT
Upon receipt of the machine packed, you are
kindly requested to immediately report to the
forwarding agent any damage suffered by the
packing during the transport.
In case of damages to the machine as well, the
insurance company of the forwarding agent will
be held responsible only if these damages have
been reported immediately.
Only competent personnel equipped with the
necessary protection must undertake all the
installation operations.
Do not use water jets against the machine for
any reason and avoid sudden movement or
violent blows.
Do not carry the machine by hand, but only by
forklift truck or tackle. It is advisable to move the
machine complete with the packing to where it is
to be installed and then unpack the machine.
UNPACKING AND LAYING OF
THE MACHINE
(SEE DRAWING PAGE 10-2)
Proceed as following:
a) Remove the box and verify that the machine
has not suffered
transport.
C H A P T E R 4
damages during the
Page 4-1
b) Sling the machine
roper (verify that
total weight of the machine), one at the
rear and the other
of machine; then lift it by means of
forklift truck or tackle and place it where it
must be installed, without moving it by
hand.
c) Connect accessories, if present (see next
paragraphs).
d) When installation
carefully refit all the panels, protection
devices and the accessories.
Various distances
other equipment must be observed during
the installation of the machine in order to
ensure smooth
maintenance.
The equipment does not require any fixing to the
floor.
It is recommended that the equipment should be
installed dead level
HOW TO ASSEMBLE
THE HEIGHT ADJUSTMENT FEET
TO THE TABLE
(SEE DRAWING PAGE 10-4 FIG.1,2)
The unit height can be altered manually, from
750mm to 930mm, by the relevant small feet in
the following way:
a) Remove the two plate parts "POS. 31" fixed
on the side of the unit column, with a
screwdriver (see page FIG. 1).
b) Fit the four threaded bars "POS. 42" and the
feet "POS. 43", as shown in FIG. 2.
By lifting the unit on the right you can fit the
left foot and on the left, you can fit the right
foot.
c) Lock the nuts so that unit is adjusted to the
required height.
E N G L I S H
by means of
are suitable for
at the front
has been completed,
from the walls
operation and good
two
the
side
and