pony CLASSIC 110 Instalación Funcionamiento Y Mantenimiento página 21

E N G L I S H
HOW TO ASSEMBLE THE
IRON REST AND THE CABLE
HOLDER
(SEE DRAWING PAGE 10-5 FIG. 3)
Proceed in the following way:
a) Position the silicon part "POS. 33" on the iron
rest "POS. 32" through the four available
bolts.
b) Assemble the cable holder "POS. 34" and fix
same with the relevant nut.
HOW TO ASSEMBLE THE
PEDAL GROUP
(SEE DRAWING PAGE 10-5 FIG.4)
Proceed in the following way:
a) Assemble the pedal group to the unit frame
fitting the two screws available, in the
corresponding holes located on the frame
itself.
The two sets adjustment holes are to fix the
pedals to the wished distance from the table.
HOW TO FIT THE TABLE
COVER
(SEE DRAWING PAGE 10-6)
a) Put the mesh followed by the felt "POS. 35",
making it flush to the buck.
b) Thread the 2 rods A and B into the cloth
cover "POS. 36".
c) Put on the cloth cover "POS. 36" checking
that it is perfectly flush to the board.
d) Hook one edge of the springs to the rod A,
checking that the cords "POS. 40" are not
caught.
C H A P T E R 4
e) Hook the second edge of the rod B by
running the springs under the buck and
checking that the cords "POS. 40" are not
caught.
f) Pull at the same time the two ends of the
cords "POS. 40".
HOW TO ASSEMBLE THE
GARMENT TRAY AND THE
GARMENT TRAY COVER CLOTH
(SEE DRAWING PAGE 10-7)
Proceed as follows:
a) Assemble
inserting it into the two holes placed under
the finishing board and make it came out
from the two plate supports.
b) Put on the elasticised cloth "POS. 37" on the
garment tray "POS.35".
HOW TO ASSEMBLE THE ARM
(SEE DRAWING PAGE 10-8)
Proceed as follows:
a) Fix the flange of the arm shape "POS. 40"
at the side of the board by means of the 4
issued bolts "POS. 48".
b) Lubricate the threaded joints: if using the arm
it would have an excessive slack, screw the
arm clockwise (conical threads).
c) Assemble the arm "POS. 53" screwing it
clockwise into the flange "POS. 51".
d) Assemble the shape "POS. 54" screwing it
clockwise in the arm "POS. 53". In case of
heated shape:
♦
Connect the socket "POS. 56" on the
rear side of the frame of the machine
and carry out the electric connection
(see electric circuit).
♦
Put the plug of the heated form "POS. 55"
in the socket "POS. 56" and hook them.
♦
Fix the electric cable to the arm "POS. 53"
by means of the two springs "POS. 61".
Page 4-2
E N G L I S H
the garment tray
SHAPE
"POS. 35"