Electrical Connection; Preliminary Controls - pony CLASSIC 110 Instalación Funcionamiento Y Mantenimiento

E N G L I S H
A gate valve must be fitted after the drain to
avoid backpressure.
A ball valve must be fitted on the condensation
return pipe "POS. 68" (1/2" gas pipe) to allow the
isolation of the machine from the plant.

ELECTRICAL CONNECTION

(SEE DRAWING PAGE 10-12)
Ensure that the mains voltage and phase
correspond with the data given on the machine
specification plate (see page 2-1).
Prepare an electrical
indicated on the table shown in the drawing on
page 10-5.
Insert the cable in the holder "POS. 8" and
connect with the clamps to the electrical current.
The electrical supply line must be fitted with an
automatic differential heat safety cutout switch
30 mA with a mechanical plug and socket
block.
The machine as per the rules in force must be
connected to a good earth, or the guarantee will
not be honoured.
Before first testing the machine, check that none
of the electrical connectors have worked loose
during transport.
After connection to the electricity supply, check
the rotation direction of the motors (fan). If the
direction is wrong, invert the connection of two
of the three phases supply wires.
Replace all the panels and protection devices
when the electrical connections have been
completed.
USE OF THE TABLE

PRELIMINARY CONTROLS

a) In case of machine with condensate
separator for finishing iron, check that
the ball valves fitted on the steam pipe "POS.
67" and on the condensation return pipe
"POS. 68" are open (see page 10-11).
b) In case of machine with steam/air spotting
gun, check that the ball tap for the
compressed air feed "POS. 25" is open
(see page 10-10)
C H A P T E R 4
line dimensioned as
Page 4-4
At first, when the machine is cold, the steam will
condense rapidly and it is therefore advisable to
wait a few minutes before starting work so that the
condensation can be drained off.
If this is not done, condensation formed will
emerge from the boards and the iron, damaging
the garments being processed.
START-UP OF THE MACHINE
(SEE DRAWING PAGE 13-1)
a) Turn on the general electrical supply switch.
b) Turn on the main switch "POS. 79" on the
electrical panel of the machine.
c) In case of machine with condensate
separator for finishing iron, turn on the
switch "POS. 85".
USING THE TABLE
(SEE DRAWING PAGE 13-1)
The board heat temperature is controlled by the
thermostat "POS.
temperature that can be set is 90°C=190°F.
N.B.: The entire heated surface can damage
clothing if they remain in contact with it for a long
time. Therefore, do not leave clothing on the
ironing surface for prolonged period of time.
To obtain vacuum in the table, proceed in the
following way:
a) Press pedal "POS. 86" to obtain vacuum in
the table. Vacuum is used to fix trouser
creases and to finishing garments made from
heavy materials (cotton etc.) or on garments
that are very creased.
b) In case of machine with arm shape, rotate
the lever "POS. 48" gradually and clockwise
to obtain the necessary vacuum.
USING THE STEAM IRON
(FOR MACHINES WITH CONDENSATE
SEPARATOR)
(SEE DRAWING PAGE 13-1)
Proceed as follows:
a) A few minutes before beginning the finishing
operation switch on the iron switch "POS. 85"
and check that the knob of thermostat is
about at the centre of the middle quadrant.
E N G L I S H
83"; the maximum