Troubleshooting; Corrective Action - Harbor Breeze E-AM54AI5LKL Manual Del Usuario

TROUBLESHOOTING

If you have any questions regarding the product please call customer service at 1-800-527-1292,
8:30 a.m. - 5 p.m., CST, Monday - Friday.
Warning: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not move.
Noisy operation.
Excessive wobbling.
Fan operates but lights
fail. (if applicable).
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Plugs not connected properly.
1. Blades (L) are loose.
2. Cracked blade (L).
3. Full range dimmer switch.
4. Fan is new.
1. Blades (L) are loose.
2. Blade arms (K) incorrectly
attached.
3. Unbalanced blades (L).
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing
yoke is (are) not tightened properly. securely.
7. Set screw on hanging ball is not
tightened properly.
1. Bulb(s) not installed correctly.
2. Wires in canopy (B) not wired
properly.
3. Wall switch to fan is off.

CORRECTIVE ACTION

1. Push switch firmly to the right or
to the left.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
(B) and check all connections.
4. Check that male and female
plugs in switch housing (H) are
connected properly according to
instructions on page 13.
1. Tighten all blade screws (AA).
2. Replace blade (L).
3. Replace with an approved
speed control device.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High
speeds.
1. Tighten all blade screws (AA).
2. Re-install blade arms (K).
3. Switch one blade (L) with a
blade (L) from the opposite side.
4. Turn power off. Carefully loosen
canopy (B) and verify that
mounting bracket (C) is secure.
5. Use a longer downrod (A) or
move fan to another location.
6. Tighten yoke set screw(s)
7. Carefully loosen and lower
canopy (B) and verify that set
screw on hanging ball is tightened
securely.
1. Re-install bulb(s).
2. Check wires in canopy (B) and,
if necessary, re-wire according to
instructions on pages 9 and 10.
3. Make sure that wall switch to fan
is on.
16