Final Installation - Harbor Breeze E-AM54AI5LKL Manual Del Usuario

FINAL INSTALLATION

1.
Locate two canopy mounting screws (R) on underside of
mounting bracket (C) and remove canopy mounting
screw (R) closest to the open end of of the mounting
bracket (C). Partially loosen the other canopy mounting
screw (R). Lift canopy (B) to mounting bracket (C).
Place rounded part of slotted hole in canopy (B) over
loosened canopy mounting screw (R) in mounting
bracket (C) and push up. Twist canopy (B) to lock.
Re-insert canopy mounting screw (R) that was removed,
and then tighten both canopy mounting screws (R)
securely. Slide canopy cover (O) up to canopy (B),
aligning rounded part of slotted holes in canopy cover
(O) with screwheads in bottom of canopy (B). Turn
canopy cover (O) to the right (clockwise) until it stops.
(Fig. 1)
Hold blade (L) in between blade arm (K) and blade
2.
plate (J) and align holes. Insert three blade screws
(AA), along with fiber blade washers (BB), with fingers
first and then tighten blade screws (AA) securely with
a Phillips screwdriver. (Fig. 2) Repeat for the
remaining blades (L).
3. Insert only one motor screw (P) through blade arm
(K) to attach blade arm (K) to motor using one of
the 5.4M/M lock washers (Q) and one of the motor
screws (P) that were previously removed (Step 5,
page 7). Partially tighten motor screw (P). (Fig. 3)
Repeat with remaining blade arms (K).
Insert remaining motor screws (P) with 5.4M/M
lock washers (Q). Tighten all motor screws (P)
securely.
1
2
K
3
11
A A
R
O
AA
BB
L
Q
P
B
J
E
K