Definitions - Safety Guidelines; Safety Instructions; Loading Tool - Bostitch BRN175 Manual De Operación Y De Mantenimiento

Clavadora para techos con bobina

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

When using any pneumatic tool, all safety precautions , as outlined below, should be followed to avoid the

risk of death or serious injury. Read and understand the instructions before operating the tool. This manual

contains information that is important for you to know and understand. This information relates to protecting

YOUR SAFETY and PREVENTING EQUIPMENT PROBLEMS. To help you recognize this information, we use the

symbols below. Please read the manual and pay attention to these symbols.

Indicates an imminently hazardous situation which, if not avoided, will result in death or

serious injury.

Indicates a potentially hazardous situation which, if not avoided, could result in death or

serious injury.

Indicates a potentially hazardous situation which, if not avoided, may result in minor or

moderate injury.

Indicates a situation which, if not avoided, may result in property damage.

EYE PROTECTION which conforms to ANSI specifications and provides protection against

flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and

others in the work area when connecting to air supply, loading, operating or servicing this

tool. Eye protection is required to guard against flying fasteners and debris, which could

cause severe eye injury.

The employer and/or user must ensure that proper eye protection is worn. Eye protection

equipment must conform to the requirements of the American National Standards Institute,

ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded spectacles

and face shields alone do not provide adequate protection.

Additional Safety Protection will be required in some environments. For example, the

working area may include exposure to noise level which can lead to hearing damage. The

employer and user must ensure that any necessary hearing protection is provided and used

by the operator and others in the work area. Some environments will require the use of

head protection equipment. When required, the employer and user must ensure that head

protection conforming to ANSI Z89.1 is used.

Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as

tool may explode, possibly causing injury.

never connect to a supply which can exceed 200 psi as tool may burst, possibly causing

injury.

The connector on the tool must not hold pressure when air supply is disconnected. If a wrong

fitting is used, the tool can remain charged with air after disconnecting and thus will be able

to drive a fastener even after the air line is disconnected possibly causing injury.

Do not pull trigger or depress contact arm while connected to the air supply as the tool may

cycle, possibly causing injury.

Always disconnect air supply: 1.) Before making adjustments; 2.) When servicing the tool; 3.)

When clearing a jam; 4.) When tool is not in use; 5.) When moving to a different work area, as

accidental actuation may occur, possibly causing injury.

When loading tool: 1.) Never place a hand or any part of body in fastener discharge area

of tool; 2.) Never point tool at anyone; 3.) Do not pull the trigger or depress the trip as

accidental actuation may occur, possibly causing injury.

Always handle the tool with care: 1.) Never engage in horseplay; 2.) Never pull the trigger

unless nose is directed toward the work; 3.) Keep others a safe distance from the tool while

tool is in operation as accidental actuation may occur, possibly causing injury.

The operator must not hold the trigger pulled on contact arm tools except during fastening

operation as serious injury could result if the trip accidentally contacted someone or

something, causing the tool to cycle.

Keep hands and body away from the discharge area of the tool. A contact arm tool may

bounce from the recoil of driving a fastener and an unwanted second fastener may be driven

possibly causing injury.

BRN175_9R209323_MAN_kf V2_multi.indd 3