Loading The Tool - Bostitch BRN175 Manual De Operación Y De Mantenimiento

To install an air fitting
1. Wrap the male end of the fitting with thread seal tape prior to assembly to
eliminate air leaks.
2. To install a 1/4" (6.4 mm) fitting: screw it directly into the air inlet and tighten
firmly. NOTE: If an adapter is in the air inlet, remove it prior to inserting the
fitting.
3. To install a 3/8" (9.5 mm) fitting: screw the fitting into the 3/8" (9.5 mm) adapter
and then into the air inlet of the tool and tighten firmly.
OPERATION:
PREPARING THE TOOL
Tools at the beginning of this manual. Always wear eye and ear protection when
operating this tool. Keep the nailer pointed away from yourself and others. For
safe operation, complete the following procedures and checks before each use of
the nailer.
To reduce the risk of damage to the tool, only use BOSTITCH pneumatic
tool oil or a non-detergent SAE 20 weight oil. Oil with additives or detergent will
damage tool parts.
1. Before you use the nailer, be sure that the compressor tanks have been
properly drained.
2. Lubricate tool:
a. Use BOSTITCH pneumatic tool oil or a non-detergent S.A.E. 20 weight oil.
DO NOT use detergent oil or additives as they will damage O-rings and
rubber parts.
b. Use a filter when possible.
c. Add 5 to 7 drops of oil in the air fitting a least twice a day.
3. Wear eye and ear protection.
4. Ensure canister is empty of all fasteners.
5. Check for smooth and proper operation of contact trip. Do not use tool if
assembly is not functioning properly. NEVER tamper with the contact trip.
NEVER use a tool that has the contact trip restrained in the actuated position.
6. Check air supply: Ensure air pressure does not exceed recommended
operating limits; 70 to 120 psi, (4.9 to 8.3 bar, 5 to 8.5 kg/cm
7. Keep tool pointed away from yourself and others.
8. Connect air hose.
9. Check for audible leaks around valves and gaskets. Never use a tool that leaks
or has damaged parts.
supply and engage trigger lock before performing maintenance, clearing a
jammed fastener, leaving work area, moving tool to another location or handing
the tool to another person.
LOADING THE TOOL (FIG. 1–6)
personal injury may result.
BRN175_9R209323_MAN_kf V2_multi.indd 6
Read the section titled Important Safety Instructions for Pneumatic
To reduce the risk of personal injury, disconnect tool from air
Keep the tool pointed away from yourself and others. Serious
6 - ENG
).
2
1/28/15 7:41 AM