Mode Setting - DELTACALOR Kompact Manual De Usuario Y De Instalación

Closed window
This function is intended to exit the frostfree mode triggered by the opening of a window on
a cold climate. It can detect, automatically an increase of the ambient temperature of the room
where the heater is installed, after closing the window and placing it in the previous set operating
mode before the opening detection. When the function is deactivated, either by temperature
analysis, either by pressing on the window key, the window icon stops flashing and the radiator
resumes operation depending on the set operating mode.
Consumption indicator
1. This function is accessible by pressing and holding
tion is the report of the output's power in kWh. It is calculated on the power of the radiator
declared in the product configuration mode (Calibrate the radiator power, p.41). By default
the power is 1350W.
2. A long press on the
This function will automatically close after 5 seconds.

Mode setting

The Mode setting allows you to adapt the thermostat at user request.
To enter the Mode setting press the
Each press of the same button allows passage to the next parameter. Without any pressing to go
to the next step the product exits this mode after 120s. When entering this mode, the thermostat
shows:
– The maximum value of the comfort setpoint
The indication of this choice is displayed by the selection of the digit "1" located on the left of
the display (vertical scale of figures, 1 to 7) and the comfort setpoint value in degrees, as well as
the sun icon.
Possible modification from 22 ° C to 30 ° C by step of 0.5°C (value stored in memory).
Default: 28°C.
These modifications are carried out by the
short press on the
Example:
key (T> at 5s) will reset counter..
1
> 5s
00
00
key for 5 seconds.
key validates the setting..
00
00
00
for more than 5 seconds. Consump-
key to increase and by the
[ 39 ]
00
2
> 5s
00
key to decrease. A
00
00
00