Remove The Fork Compression Damper; Install The New Compression Damper - SRAM ROCK SHOX X Loc Full Sprint Manual Del Usuario

R e m o v e t h e F o r k C o m p r e s s i o n D a m p e r
Depending on the fork, the compression damper removal procedure will vary . For detailed
instructions on how to remove the compression damper, consult the service manual for your
fork, available at sram.com/service.
I n s t a l l t h e N e w C o m p r e s s i o n D a m p e r
1. Press the remote actuator to the unlocked position.
2. Apply a small amount of grease to the compression damper piston and topcap o-rings.
3. Insert the compression damper into the upper tube of the fork. Press down and rock it side
to side until the damper is installed. Use a torque wrench with a 24 mm crowfoot to tighten
the compression damper to 7.3 N∙m (65 in-lb).
install the crowfoot onto the torque wrench at a 90° angle to the handle to ensure an
accurate torque reading�
4. Press the remote actuator to activate the lockout.
1
24
3
7.3 N·m
(65 in-lb)
4

Remove the FoRk CompRession DampeR

15