Assembling The Microscope - Optika Italy B-380 Serie Manual De Instrucciones

7.1

Assembling the microscope

1. Insert the Bertrand lens ① in the frame and lock
the locking screw ② with the provided Allen
wrench. (Fig.1)
2. Insert the optical head on the Bertrand lens and
lock the locking screw with the provided Allen
wrench. (Fig. 2)
3. Insert both eyepieces into the tubes of the optical
head. (Fig. 3)
• One of the two eyepieces is equipped with
a crosshair for centering the entire optical
system. It is advisable to insert the eyepiece
with crosshair in the right eyepiece holder.
• The condenser is pre-installed before leaving the
factory.
• To remove the condenser use an Allen wrench
diam. 1,5 and operate on the locking screw
placed on the right side of the condenser holder.
4. Remove the dummy slider from Bertrand lens
and insert the analyser ③.(Fig. 4)
①
Page 7
②
F ig. 1 F ig. 1
F ig. 2 F ig. 2
F ig. 3 F ig. 3
③
F ig. 4 F ig. 4