Assembly 12.1 Assembly; Zi-Md500Hst - Zipper Maschinen ZI-MD500HST Instrucciones De Servicio Complementarias

12 ASSEMBLY
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
12.1 Assembly

12.1.1 ZI-MD500HST

 Position the bottom panel inside the mounting
bracket.
 Align the holes with the mounting bracket.
 Insert a long pin through holes and secure each
side with a flat washer and cotter pin.
Schneeschild:
 Mount the mounting brackets (1) & (2) to the
blades using M10×25 hex bolts, washers and
nuts.
 Mount the bracket (4) to the mounting brackets (1)
& (2) using in total four M10x25 hex bolts and
washers
 Mount the bracket (5) onto the snow blade using 2
hex-bolts.
 Mount the Landing Leg weldment onto the snow
blade. Place the landing leg weldment into the
bracket and fix it with the hex bolt (6) and nut
(7).
 Install the already assembled snow blade onto
the machine with the two delivered pins.
 The snow blade can be tilted in three positions.
Straight position place bolt (1) in position
(Pos1). Tilt it to the right place bolt (1) in
position (Pos2). Tilt it to the right place bolt (1)
in position (Pos3).
ZIPPER MASCHINEN GmbH
ZI-MD500HST
www.Zipper-Maschinen.at
1
2
1
2 3
1
5
1
Pos3
ASSEMBLY
3
2
4
5
6
7
Pos2
Pos1
31