Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
13.3.2 Refuel
Use only unleaded fuel with min. 95 octane (corresponding device fuel)
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
Follow the safety instructions for fuel control. Filter the fuel before refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up
spilled fuel.
13.3.3 Check hydraulic oil
In the hydraulic oil tank must be approximately 3,5 liters of hydraulic oil (HL 46 or similar)
ZIPPER MASCHINEN GmbH
ZI-MD500HST
1. To check the engine oil level, place the machine on a flat,
level surface. Switch off the motor and wait for ten
minutes to allow the circulating oil to collect in the oil
pan.
2. Unscrew the oil-dipstick and wipe with a clean, lint-free
cloth or a non-fibrous paper towel.
3. Push the dipstick back into the opening as far as possible,
but do not screw it in. (Make sure that the dipstick is
really pushed in completely - occasionally it gets
jammed).
4. Pull out the oil dipstick again and check the oil level.
There are two markings for this - see illustration on the
left.
5. If the oil level is low, fill up the recommended oil to the
upper rim at the maximum (maximum filling volume: see
technical data: do not overfill!)
6. Insert the oil dipstick again and retighten it.
7. Wipe away oil residues.
www.Zipper-Maschinen.at
WARNING
NOTICE
1. Refuelling only outdoors!
2. Before removing the fuel tank cap, turn the motor off
and let the machine cool down.
3. Clean the fuel tank cap area.
4. Remove the fuel tank cap carefully.
5. Visual check of the filling level.
6. If necessary, refill with fuel.
7. Fuel tank capacity: see technical data. Fill tank only
up to 1.5 cm below the rim of the filler neck, so that
the fuel has place for expansion.
NOTICE:
use fuel with the appropriate octane
number (RON 95).
8. Replace and tighten the fuel tank cap.
9. Wipe any fuel residues and wait until it evaporates.
OPERATION
33
Publicidad
Tabla de contenido
